Speedway is a town of about 14,400 people inside Marion County with its own building department, so permits here come from the Town of Speedway Building Commissioner’s Office, not from Indianapolis. Each discipline (structural, electrical, plumbing, and heating and cooling) needs its own permit, fees are set by Town Council resolution, and new construction costs 10 cents per square foot with a $100 minimum for houses. Inspections are called in to the inspector by phone and are done by the end of the following day.
What requires a building permit in Speedway?
The town’s fee schedule is the clearest list of what Speedway permits. It covers far more than new buildings: replacement roofs, windows, siding, gutters and trim on houses each carry a permit fee, as do signs, demolition and moving a structure.
Building and structural
- New primary structures and additions, including garages, porches, sheds and carports
- Remodels, interior or exterior, that involve no footing or foundation
- Roofing, new or replacement
- Windows, siding, gutters and trim on houses
- Demolition of houses, garages and larger buildings
- Relocation of a structure
- Ground, roof and wall signs
- Grandstands and suites
Trade permits
- Electrical service upgrades, relocations and change-outs
- Electrical work for remodels, additions and new houses
- Electric heating and cooling units
- Furnace, air conditioner and heat pump installation or replacement, and ductwork
- Plumbing for new structures, repairs and alterations, reconnections and water heaters
- Temporary electrical service
For work the schedule does not list, its “Miscellaneous” lines send applicants to the Building Commissioner, or to the electrical, HVAC or plumbing inspector for those trades. The remodel rate may not be used when a footing or foundation is involved.
What Speedway decides and what the state holds
Speedway sets its own permit fees by Town Council resolution, runs its own inspection department and decides its own inspection stages; its Clerk-Treasurer publishes the town’s Municipal Code, ordinances, resolutions and zoning information. The fee schedule itself splits most permits into Class 2 (residential) and Class 1 (commercial) rates, following the state’s two building classes. A Class 1 building also needs the state’s Construction Design Release before construction unless the work is exempt; the town’s permit is separate from that release.
Short on time to read all of this?
Get a free quote →Speedway building department: who handles permitting
The Town of Speedway Building Commissioner’s Office and Inspection Department issues permits and inspects commercial and residential work. The town lists it as a division of the Police Department on its website, and the permit forms and fee schedule are published by the Clerk-Treasurer. Robert Stevens is listed as Building Commissioner. Separate inspectors handle electrical and heating and cooling work.
| Detail | Information |
|---|---|
| Building Commissioner’s Office | 317-246-4122 |
| Clerk-Treasurer | Speedway Municipal Center, 5300 Crawfordsville Rd., Speedway, IN 46224; 317-246-4111 |
| Fees | Set by Town Council resolution; re-inspection and extra inspection fees paid to the Clerk-Treasurer |
| Moving a structure | Contact the Clerk-Treasurer’s Office |
| Inspections | Called in by telephone to the inspector for each trade |
Speedway is one of the towns and cities in Marion County that keep their own governments; an address inside the town line is permitted by the town, while property across the line in Indianapolis goes to Indianapolis’s own offices.
Speedway permit types
The town posts two application forms on its Construction Permit Applications and Fee Schedule page: a Structural Permit Application for building work and a Mechanical Permit Application for mechanical work. Because each discipline needs its own permit, a typical house project files more than one.
Residential permits
- New houses and additions, including garages, porches, sheds and carports: a structural permit at 10 cents per square foot ($100 minimum), plus the electrical, plumbing and heating and cooling permits the work needs.
- Remodels of interior or exterior work without a footing or foundation: 10 cents per square foot, $65 minimum.
- Exterior replacement work: roofing ($60), windows ($10 per window, $65 minimum), siding ($10 per square of siding, $65 minimum), gutters or trim ($65).
- House or residential garage demolition: $50.
- Trade-only jobs such as a furnace change-out, a water heater or a service upgrade, each on its own permit.
Building or remodeling a home here? Alliance handles residential permit expediting, so the crew isn't waiting on the counter.
Commercial permits
Commercial (Class 1) work uses the same disciplines at commercial rates: 10 cents per square foot with a $150 minimum for new construction, $120 minimum for remodels, $8 per $1,000 of job cost for roofing, and per-square-foot or job-cost rates for electrical, HVAC and plumbing. Commercial, industrial and multi-family demolition is priced by ground area, with half the ground-area fee added for each extra story, and smokestacks, above-ground storage tanks and overhead hoppers have their own rate. The schedule also prices grandstands and suites by area.
Not sure this scope needs a permit?
Get a free quote →For tenant improvements and new commercial builds, Alliance handles commercial permit applications through issuance. More on this: commercial building permits explained.
What comes before the building permit
- Zoning. The Clerk-Treasurer’s pages carry the town’s Zoning page next to its Municipal Code and ordinances.
- State design release. Class 1 buildings need the release from the Indiana Department of Homeland Security before construction, unless the work is exempt.
- Moving a building. A relocation needs a permit arranged through the Clerk-Treasurer, with the fee based on the town resources the move requires.
- Signs. Every ground, roof or wall sign needs a sign permit; illuminated and two-sided signs pay more.
- Business and event permits. The Clerk-Treasurer also handles business licenses and event permits, which are separate from construction permits.
Speedway permit costs and fees
Speedway’s fees are set by Town Council resolution and published on the Clerk-Treasurer’s fee schedule page. Class 2 means one- and two-family residential work and Class 1 means commercial.
Rather talk it over?
Call 1-855-478-4290 →| Work | Fee |
|---|---|
| New construction or addition, residential / commercial | $0.10 per sq ft; $100 / $150 minimum |
| Remodel, residential / commercial (no footing or foundation) | $0.10 per sq ft; $65 / $120 minimum |
| Roofing, residential / commercial | $60 / $8 per $1,000 of job cost, $100 minimum |
| Windows / siding / gutters or trim (residential) | $10 per window, $65 minimum / $10 per square, $65 minimum / $65 |
| Demolition, house or garage | $50 |
| Demolition, commercial, industrial or multi-family | $70.50 up to 2,000 sq ft of ground area; $135 to 4,000; $200 to 10,000; $285 to 20,000; $560 over 20,000; plus 50% for each extra story |
| Signs | $25 up to 200 sq ft, plus $4 per extra 100 sq ft; $30 more if illuminated; doubled if two-sided |
| Electrical, residential: service upgrade, remodel or addition, temporary service | $60 each; remodel or addition with service relocation $100 |
| Electrical, new house | $10 per $1,000 of job cost, $100 minimum |
| Electrical, commercial: new panel, branch circuits / new building | $100 each / $0.10 per sq ft, $100 minimum |
| HVAC, residential: heating or cooling / both / ductwork | $50 per unit / $100 / $35 added |
| HVAC, residential: coil, condenser, heat pump or solar panel | $65 per unit |
| HVAC, commercial | $10 per $1,000 of job cost; $50 minimum per heating or cooling unit, $100 for a combined system |
| Plumbing, residential: new structure / repair or alteration / reconnect / water heater | $55 / $45 / $35 / $25 per unit |
| Plumbing, commercial: new structure | $0.10 per sq ft, $55 minimum |
| Re-inspection or additional inspection | $50 per occurrence |
| One-year permit renewal | $50 per permit |
Worked example for a new 1,800-square-foot house: the structural permit is 1,800 × $0.10 = $180, the plumbing permit for a new structure is $55, and combined heating and cooling is $100 plus $35 for new ductwork, for $370 before the electrical permit. The electrical permit for a new house is $10 per $1,000 of job cost with a $100 minimum, so it depends on the cost declared on the application.
Demolition of larger buildings is priced by ground area and story count. Taking down a two-story commercial building with 3,000 square feet of ground area falls in the up-to-4,000 band at $135, and the second story adds half of that, $67.50, for $202.50. A house or residential garage is a flat $50 whatever its size.
Trade permits and who may pull them
Speedway treats each trade as its own discipline with its own permit, inspector and inspections. Next to the Structural Permit Application, the town posts a Mechanical Permit Application, and the fee schedule names an electrical inspector, an HVAC inspector and a plumbing inspector as the contacts for trade work the schedule does not list.
Rather not deal with the building department?
Get a free quote →- Electrical: residential and commercial permits for services, panels, branch circuits, remodels, new houses and electric heating or cooling units.
- HVAC and refrigeration: heating and cooling systems, ductwork, coils, condensers, heat pumps and solar panels.
- Plumbing: new structures, repairs and alterations, reconnections and water heaters; plumbing contractors hold Indiana’s state license.
The construction permit pages do not set out a contractor license or registration rule of their own; the town’s Vendors and Business Licenses pages are separate.
How to apply for a Speedway building permit
Work across the town line in Indianapolis is permitted by Indianapolis, not the town.
Decide which of structural, electrical, plumbing and heating and cooling the job involves; each needs its own permit.
Use the Structural Permit Application and the Mechanical Permit Application from the Clerk-Treasurer’s permit page.
Work out the fee from the schedule by square footage, unit count or job cost; for anything not listed, contact the Building Commissioner or the trade inspector.
Contact the Building Commissioner’s Office at 317-246-4122; the permit is issued once the fee is paid, as the town’s permit rules require.
Phone the inspector for each trade at each required stage.
Review, corrections and what causes delay
The town’s permit rules require the permit fee to be paid before the permit is issued, and a failed inspection holds the job until the $50 re-inspection fee is paid in full. Permits stay valid for one year from issue; a one-year renewal approved by the commissioner or inspector costs $50. For one- and two-family work, IC 36-7-2.5 has since January 1, 2026 required the unit to answer within 3 business days whether an application is complete and to finish plan review within 7 business days.
Inspections in Speedway
The town’s Required Inspections page sets the stages for each discipline:
Want this handled start to finish?
Get a free quote →- Structural: footing excavation before concrete; under-slab preparation and insulation before the slab is poured; the completed foundation before framing; the corner brace nailing pattern before house wrap; completed framing before insulation and drywall; brick at 4 to 6 feet of height; and the final.
- Electrical, plumbing, and heating and cooling: under-slab (where installed), rough-in and final; anything under a slab must be inspected before the slab is poured.
Call the inspector for the trade by telephone when the work is ready, and keep the job site open for 48 hours after calling; inspections are completed by the end of the following day. If an inspection fails, the $50 re-inspection fee must be paid in full before the re-inspection. The Building Commissioner and inspectors may add inspection stages, and fees for extra inspections or re-inspections are paid to the Clerk-Treasurer before the certificate of occupancy is issued.
Indiana building code in Speedway
FEMA’s Community Status Book lists the Town of Speedway (180162) under the Indianapolis–Marion County community number 180159, with flood maps effective August 14, 2024.
Before construction starts on a Class 1 structure — one used by the public, by three or more tenants, or by anyone working as another’s employee — Indiana requires a state Construction Design Release, unless the work is exempt under 675 IAC 12-6-4. One- and two-family dwellings and qualifying townhouses are Class 2 and are permitted locally where an ordinance requires it. Indiana enforces the 2014 Indiana Building Code and the 2020 Indiana Residential Code. Class 1 and Class 2 in Indiana
Speedway permit search and official resources
Speedway does not post a public permit search on its permit pages. For a copy of a past permit or inspection record, contact the Building Commissioner’s Office (317-246-4122) or the Clerk-Treasurer (317-246-4111); the Clerk-Treasurer also publishes the town’s resolutions, ordinances and annual financial reports.
- Speedway Building Commissioner’s Office
- Construction permit applications and fee schedule
- Required inspections
- FEMA Community Status Book, Indiana
Inspections are where schedules slip.
Get a free quote →Speedway building permit FAQs
Does Indianapolis issue building permits in Speedway?
No. Speedway is a separate town inside Marion County, and its Building Commissioner’s Office issues permits there.
How much is a building permit for a new house in Speedway?
The structural permit is 10 cents per square foot with a $100 minimum; electrical, plumbing and heating and cooling permits are added separately.
Do I need a permit to replace my roof in Speedway?
Yes. A residential roof, new or replacement, is a $60 permit.
Do I need a permit for new windows or siding?
Yes. Windows are $10 each with a $65 minimum, siding $10 per square with a $65 minimum, and gutters or trim $65.
How do I schedule an inspection?
Phone the inspector for that trade. Keep the site open for 48 hours; inspections are completed by the end of the following day.
How long is a Speedway permit good for?
One year from issue. A one-year renewal costs $50 per permit.
What does a failed inspection cost?
$50 per re-inspection, paid in full before the inspector returns.
Simplify Speedway permitting with Alliance Permitting
Alliance Permitting is a permit documentation and submission company in Indiana. We prepare your paperwork, file it correctly and coordinate with the permitting authority through issuance. We are not a contractor and we do not perform licensed plan review or inspections; that work stays with your licensed team and the jurisdiction.
Ready to break ground in Speedway sooner?
Let Alliance prepare, file, and track your Speedway permits while your crew stays on the job.
More Indiana permitting guides
Marion County
Read guide →Beech Grove
Read guide →Indianapolis
Read guide →Spencer County Building Permit Guide
Read guide →St. John Building Permit Guide
Read guide →St. Joseph County Building Permit Guide
Read guide →This guide is provided by Alliance Permitting for general information about Speedway permitting. Requirements, fees, and procedures change; confirm details with the permitting authority before relying on them.